Home / Glossary

Plain language

Glossary

The terms these guides keep using, in one place.

Short definitions for terms used in these guides. They are general language, not a substitute for a service manual.

Solid axle (beam axle)
A single housing that carries both wheels on one end of the vehicle. Wranglers use this layout front and rear.
IFS
Independent front suspension: each front wheel moves on its own arms and joints. Liberty, 2005-up Grand Cherokees, and later Jeep crossovers use this kind of front end.
Track bar (Panhard bar)
The bar that locates a solid axle from side to side. Worn bushings or loose bolts here are a common death-wobble finding.
Drag link
The steering link from the pitman arm (or steering box output) toward the axle. After a lift, it should stay close to parallel with the track bar.
Tie rod
The link that connects the steering knuckles and helps keep the two front wheels pointed together (toe).
Bump steer
Unwanted steering as the suspension moves, often from a drag link and track bar that are no longer working through similar angles.
Caster
The rearward or forward tilt of the steering axis. It helps the Jeep go straight. A lift can change it; an alignment should measure it.
Death wobble
A violent side-to-side front-end oscillation on a solid-axle Jeep, often after a bump at highway speed. See the steering page.
Locker
A differential that can lock both axle shafts together so both wheels turn at the same speed. Factory Rubicon Tru-Lok units are driver-controlled, with conditions described in the owner’s manual.
Limited-slip (Trac-Lok)
A differential that biases torque to the wheel with more grip without fully locking. Stellantis lists an optional Trac-Lok rear on some non-Rubicon Wranglers.
Transfer case low range
The lower gear set in a two-speed transfer case. Jeep lists Command-Trac at 2.72:1 on many Sport/Sahara models and Rock-Trac at 4:1 on Rubicon models.
Command-Trac / Rock-Trac / Selec-Trac
Jeep 4x4 system names. Command-Trac is the part-time system commonly listed on Sport and Sahara; Rock-Trac is the Rubicon system with a 4:1 low range; Selec-Trac is described by Stellantis as a full-time option on some later Wranglers.
Sway-bar disconnect
A way to disconnect the front anti-roll bar for more wheel travel off-road. Later Rubicons list an electronic disconnect. Reconnect it for the highway, following the manual.
Heim (rod end)
A spherical rod-end bearing used on some heavy-duty or custom steering and suspension links.
Johnny Joint
A trademarked flex joint used on some control arms and track bars, including DOR Ram arms. DOR’s replacement joints are listed for those Ram arms, not as Jeep bolt-ons.
Bill of material (BOM)
The number stamped on a Dana axle tube that identifies the exact housing. The most reliable way to confirm an axle on a used Jeep.
Unibody
A structure where the body and frame are one piece. The XJ Cherokee is a unibody 4x4 with solid axles, which is a different repair and rust conversation than a body-on-frame Wrangler.

Last reviewed 2026-11-10. General information only: the vehicle maker’s and your parts maker’s instructions come first.